Kinematics of Selected parts of metal Cutting machine

Jozef Filas¹ and Vladimír Marton^1,

¹Faculty of Mechanical Engineering, Department of Applied Mechanics and Mechatronics, Technical University of Košice, Letná 9, Košice, Slovak Republic

Cite this paper:
Jozef Filas and Vladimír Marton. Kinematics of Selected parts of metal Cutting machine. American Journal of Mechanical Engineering. 2013; 1(7):241-245. doi: 10.12691/ajme-1-7-18

Abstract

This article deals with kinematics of mechanical part of lathe in cases of highest and lowest speeds during machining for selected parts of the machine. Calculations are made or cut in startup mode in steady state. Not stated all calculations because of their large-scale. Calculations are for real machine tool, which is used in workshop practice. Analogy, it can do the same when other machine in which the gear unit and the various modes of operation.

Keywords:
metal cutting machine lathe kinematics

This work is licensed under a Creative Commons Attribution 4.0 International License. To view a copy of this license, visit http://creativecommons.org/licenses/by/4.0/

Figures

References:

[1]	Jančina,J., Pekárek, F.,: MECHANIKAII-KINEMATIKA. Bratislava, 1987.
[2]	Medvec, A., Stradiot, J., Záhorec, O., Caban, S.,: MECHANIKAIII-DYNAMIKA, Bratislava 1996.
[3]	Šimčák,F.,Trebuňa,F.,:METÓDYEXPERIMENTÁLNEJANALÝZYNAPATOSTI, Košice, 2011.
[4]	Šolek, P.,: TECHNICKÁMECHANIKA. Bratislava, 2009.
[5]	Marton,V.,: Kinematickáanalýzapohonuobrábaciehostroja (Bakalárska práca), SjF TU Košice, 2013.