1Faculty of Mechanical Engineering, Department of Applied Mechanics and Mechatronics, Technical University of Košice, Letná 9, Košice, Slovak Republic
American Journal of Mechanical Engineering.
2013,
Vol. 1 No. 7, 241-245
DOI: 10.12691/ajme-1-7-18
Copyright © 2013 Science and Education PublishingCite this paper: Jozef Filas, Vladimír Marton. Kinematics of Selected parts of metal Cutting machine.
American Journal of Mechanical Engineering. 2013; 1(7):241-245. doi: 10.12691/ajme-1-7-18.
Correspondence to: Vladimír Marton, Faculty of Mechanical Engineering, Department of Applied Mechanics and Mechatronics, Technical University of Košice, Letná 9, Košice, Slovak Republic. Email:
jozef.filas@tuke.skAbstract
This article deals with kinematics of mechanical part of lathe in cases of highest and lowest speeds during machining for selected parts of the machine. Calculations are made or cut in startup mode in steady state. Not stated all calculations because of their large-scale. Calculations are for real machine tool, which is used in workshop practice. Analogy, it can do the same when other machine in which the gear unit and the various modes of operation.
Keywords