Use FEM for Identifying Boundary Failure of Sheath Cylindrical Vessel

Ingrid Delyová^1, , Peter Sivák¹ and Darina Hroncová²

¹Department of Applied Mechanics and Mechanical Engineering, Faculty of Mechanical Engineering, Technical university of Košice, Košice, Slovakia

²Department of Mechatronics, Faculty of Mechanical Engineering, Technical university of Košice, Košice, Slovakia

Cite this paper:
Ingrid Delyová, Peter Sivák and Darina Hroncová. Use FEM for Identifying Boundary Failure of Sheath Cylindrical Vessel. American Journal of Mechanical Engineering. 2015; 3(6):186-189. doi: 10.12691/ajme-3-6-6

Abstract

This article deals with the shape bottom effect to different types of stress and deformation process at the junction of the cylindrical part of the shell vessel and its bottom. With the FEM using the SolidWorks were different types of stress and deformations of vessel determined. The calculation is designed as a static and during the research it was not taken any technical process into account such as the temperature impact or the materials nonlinearity, the internal stress. There were used a variety of vessel and also the different types of results were compared during the analysis.

Keywords:
FEM membrane state flat bottom shell bending moment boundary fault

This work is licensed under a Creative Commons Attribution 4.0 International License. To view a copy of this license, visit http://creativecommons.org/licenses/by/4.0/

Figures

References:

[1]	Křupka, V., Schneider, P., Konstrukce aparátů PC-DIR, spol. s.r.o., Brno, 1998.
[2]	Trebuňa, F., Šimčák, F., Odolnosť prvkov mechanických sústav, Emilena, Košice, 2004.
[3]	Gontarz , A., Tofil, A., Theoretical Analysis of the Buckling Phenomenon in the Upsetting Process Of Magnesium Alloy Mg4AlZn. In: Acta Mechanica Slovaca Vol. 16, No. 1, 2012, s 84-89.
[4]	Jakab, L., Analýza napätí a deformácií v nádobe s plochým dnom, Diploma work, 2013.
[5]	Kováč, J., Analýza tvaru dna nádoby na rozloženie napätí v škrupine Diploma work, 2013.
[6]	Teplý, B., Šmiřák, S., Pružnost a plasticita II. Nakladatelství VUT Brno, 1993.