American Journal of Civil Engineering and Architecture
ISSN (Print): 2328-398X ISSN (Online): 2328-3998 Website: https://www.sciepub.com/journal/ajcea Editor-in-chief: Dr. Mohammad Arif Kamal
Open Access
Journal Browser
Go
American Journal of Civil Engineering and Architecture. 2025, 13(5), 115-122
DOI: 10.12691/ajcea-13-5-1
Open AccessArticle

Physicohemical, Geotechnical and Mineralogical Characterization of Soils Use as Eco-materials

Mbairangone Samson1, , Togdjim Jonas2, Sara Galléboui1 and Kinet Ouinra1

1Civi Engineering Department, National School of Public Works (ENSTP), N’Djamena, Chad

2Mechanical Engineering Department, Higher National Institute of Sciences and Techniques of Abéché (INSTA), Abéché, Chad

Pub. Date: October 19, 2025

Cite this paper:
Mbairangone Samson, Togdjim Jonas, Sara Galléboui and Kinet Ouinra. Physicohemical, Geotechnical and Mineralogical Characterization of Soils Use as Eco-materials. American Journal of Civil Engineering and Architecture. 2025; 13(5):115-122. doi: 10.12691/ajcea-13-5-1

Abstract

The study focuses on the physical, chemical, geotechnical, and mineralogical characterization of two clay soils from N'Djamena (NDJA) and Moundou (MOD) in Chad with a view to their use in eco-construction. This characterization is essential when selecting soils for use in the manufacture of raw earth bricks. After the soil samples were taken, the work was carried out experimentally in laboratories. The results of the physicochemical study reveal a moderate natural water content (12.5%) for the N'DJA soil, compared to a very high natural water content (30.6%) for the MOD soil. The NDJA soil has a relatively low organic matter content (2.27%) compared to the MOD soil (5.11%). However, both have a loss on ignition rate (6.03% and 6.57%, respectively) and specific density (2.35 g/cm3 and 2.34 g/cm3, respectively). The NDJA and MOD soils consist of 25.2% clay, 29.4% silt, and 45.4% sand, and 21.3% clay, 43.6% silt, and 35.1% sand, respectively. The results of the chemical analysis show that the abundant oxides are SiO₂, Al₂O₃, and Fe₂O₃, whereas K₂O, CaO, BaO, MgO, Na₂O, TiO₂, and P₂O₅ are present in low quantities in the NDJA and MOD soils. The results of mineralogical analysis by X-ray diffraction (XRD) reveal that the clay in N'Djamena (NDJA) consists mainly of quartz (Q), kaolinite (ka), K-feldspar (K-f), smectite (sm), and hematite (Ha), while the clay in Moundou (MOD) also contains illite (Il) in addition to these minerals. The study showed that both soils have properties that make them suitable for use in eco-construction.

Keywords:
characterization clay soils Chad density oxides eco-construction

Creative CommonsThis work is licensed under a Creative Commons Attribution 4.0 International License. To view a copy of this license, visit http://creativecommons.org/licenses/by/4.0/

References:

[1]  Mbairangone S, Contribution a la caracterisation de sols argileux renforces par des fibres vegetales « balles de riz », Université de N’Djamena, Thèse de doctorat, 2024.
 
[2]  Houben H., Guillaud H. Traité de construction en terre, Edition parenthèses, Marseille (France) ,355p, 2006.
 
[3]  Morel J.C., Pkla A., and Walker P. compressive strength testing of compressed earth blocks. Construction and Building Materials, 15(5-6), 301-309,2001.
 
[4]  Mbairangone, S., Natmack, G. E., Bianzeube, T., Bozabe, R. K. and O. Kinet, O. Effect of rice husk on adobes in clay soils. Research Journal of Engineering Sciences,11(3), 12-21, 2022
 
[5]  Taïpabé D., Doko K. V., Datchossa T. A, Abdourahamane A. I.,Mandela T., Sanou A., Gibigaye M. Characterization of a lateritic soil in Chad with a view to its use in eco-construction. J. Mater. Environ.Sci.(16) 7, 1189-1209, 2025.
 
[6]  NF P 94-050: Reconnaissance et essais- Détermination de la teneur en eau pondérale des matériaux- méthode par étuvage. AFNOR, 1995
 
[7]  XP P 94-047. (Reconnaissance et essais - Déterminations de la teneur en matière organique d’un matériau - Méthode par calcination. 1998.
 
[8]  Qlihaa A., Dhimni S., Melrhaka F., Hajjaji N., Srhiri A. (2016). Caractérisation physico-chimique d’une argile Marocaine [Physico-chemical characterization of a morrocan clay]. J. Mater. Environ. Sci. 7 (5) 1741-1750, 2016
 
[9]  Bobet, O. Elaboration et caractérisation de matériaux bio-sourcés à base d’argile de Lougouri et coques d’arachide. Université OUAGA I Pr Joseph KI – ZERBO, Thèse de Doctorat, 2020.
 
[10]  NF EN ISO 17892-3Reconnaissance et essais géotechniques - Essais de laboratoire sur les sols - Partie 3: détermination de la masse volumique des particules solides, . 2015.
 
[11]  Togdjim J. Elaboration et caractérisation d’un composite issu de sols argileux et de diatomite pour son utilisation dans l’écoconstruction. Université de N’Djamena, Thèse de doctorat, 2025.
 
[12]  Bodian S. Faye M., Sambou V., Séne N A., Diaw I., Faye K. Caractérisation physico-chimique des matières premières argileuses de la carrière de thicky (sénégal) pour lafabrication de briques en terre. Journal de physique de la SOAPHYS,2021
 
[13]  NF EN 1097-3.. Part3 - Méthode pour la détermination la masse volumique en vrac et la porosité intergranulaire, 20 p.1998.
 
[14]  NF P 94-056. Analyse granulométrique. Méthode par tamisage à sec après lavage, AFNOR. 1996
 
[15]  NF P 94-057. Analyse granulométrique des sols. Méthode par sédimentation, AFNOR, 1992)
 
[16]  NF P 94-051. Reconnaissance et essais- Détermination des limites d’Atterberg. AFNOR, 16 p, 1993.
 
[17]  Ahouet, L., Dzaba, S., Elenga, B.D.M., Okina, S.N. and Kimbatsa, F.T. Characterization of the Activity, Mineralogy and Correlations between the Properties of Clayey Soils. Jou rnal of Minerals and Materials Characteriz ation and Engineering, 10, 410-428, 2022.
 
[18]  NF P 94-068. (1998). Reconnaissance et essais-Détermination de la valeur de bleu de méthylène d’un sol ou d’un matériau rocheux par l’essai à la tâche. AFNOR, 8p.
 
[19]  Togdjim J., Malloum S., Abderahman A. O., Abakar A., Alexis M. N., Danala S., Michel Q. Geotechnical, physicochemical and mineralogical characterizations of soil quarries in Chad with a view to their valorization in eco-construction, J. Mater. Environ. Sci., 14(2), 255-267.2023.
 
[20]  Bobet, O., Seynou, M., Zerbo, L., Bamogo, H., Sanou, I., Sawadogo, M.,. Mechanical, hydric and thermal properties of raw earth bricks amended with peanut shells. Journal of the West African Chemical Society 49, 54–64, 2020
 
[21]  Yvon, J., Liétard, O., Cases, J.-M., Delon, J.-F. Mineralogy of kaolinic clays from the Charentes. bulmi 105, 431–437, 1982.
 
[22]  Abakar A. Caractérisations mécaniques et thermiques de l’argile stabilisée par la gomme arabique et renforcée par la paille de riz. Université de Lorraine, Thèse de Doctorat, 2018.
 
[23]  NF EN ISO 14688-2. Reconnaissance et essais géotechniques – Identification et classification des sols - part 2: principe pour une classification. AFNOR, 21 p, 2018.
 
[24]  Baccour Zghal, H., Medihoud, M. & Mhiri , M. Caractérisation physicochimique et mécanique de matériaux céramiques obtenus à partir des argiles tusiennes verres céramiques & composites, 1 (2), 25‐33, 2011.
 
[25]  Seed, H., Woodward, R., & Lundgren, R Prediction of Swelling Potential for Compacted Clays. Journal of the Soil Mechanics and Foundations Division, 88, 107-131, 1962.
 
[26]  Lavie Arsène, M. I. Valorisation des gisements argileux pour la fabrication des blocs de terre comprimée. Université de Liège, thèse de doctorat, 157, 2019.
 
[27]  Sayouba, K., François, O., Bétaboalé, N., Adamah, M., Jean Claude, B. et François, Z. Evaluation des propriétés thermo-hydro-mécaniques des briques en terre comprimées (BTC) issues de la carrière de Matourkou, au Burkina- Faso. Afrique Science,vol. 15(3), 12-22, 2019.
 
[28]  Aubert, J.-E., Marcom, A., Oliva, P., Segui, P. (2015). Chequered earth construction in south-western France. J. Cult. Herit., 16, 293-298, 2015.
 
[29]  NF XP P 13- 901. . Ed. Blocs de terre comprimée pour murs et cloison. Nor 01. Association française de normalisation, 2001, Paris, AFNOR, 35p.
 
[30]  NF P 11-300. (1992). Classification des matériaux utilisables dans la construction des remblais et couches de forme d’infrastructures routière, 1992, AFNOR, 21 p
 
[31]  Abakar Ali, Riad BENELMIR, Jean-Louis TANGUIER et Abdoulaye Saleh TODJIBEL, Caractérisation de l’argile de N’djamena stabilisée par la gomme arabique, Afrique SCIENCE, 13, 330-341, 2017.
 
[32]  Magnan, J. P. Description, identification et classification des sols. Ed. Ingénieur Technique, 1997.
 
[33]  Chrétien, M., Fabre, R., Denis, A., Marache, A. Recherche de paramètres d’identification géotechnique optimaux pour une classification des sols sensibles au retrait- gonflement. Rev.Fr Géotechnique, 91-106, 2007.
 
[34]  Ouedraogo M. Stabilisation des adobes par des fibres végétales. Université OUAGA I Pr Joseph KI – ZERBO, Thèse de Doctorat, 187 p, 2018.
 
[35]  Hidalgo, C., Thiry, M., Elsass, F., & Quantin, P. Caractérisation minéralogique des argiles des sols volcaniques indurés (tepetates) de la Vallée de Mexico, pp 20- 26, janvier 1998
 
[36]  Murmu, A. L., Jain, A., & Patel, A. Mechanical Properties of Alkali Activated Fly Ash Geopolymer Stabilized Expansive Clay. KSCE Journal of Civil Engineering, 23(9), 3875‑3888, 2019.
 
[37]  Sen, A., Yokokura, T., Kankel, M.W., Dimlich, D.N., Manent, J., Sanyal, S., Artavanis-Tsakonas, S. Modeling spinal muscular atrophy in Drosophila links Smn to FGF signaling. J. Cell Biol. 192 481-495, 2011