American Journal of Civil Engineering and Architecture
ISSN (Print): 2328-398X ISSN (Online): 2328-3998 Website: https://www.sciepub.com/journal/ajcea Editor-in-chief: Dr. Mohammad Arif Kamal
Open Access
Journal Browser
Go
American Journal of Civil Engineering and Architecture. 2026, 14(2), 46-53
DOI: 10.12691/ajcea-14-2-3
Open AccessArticle

Determination of the Mechanical Characteristics of Silty Sand Improved to Granite Crushed for Use in Road Construction in Southern Benin

Kocouvi Agapi HOUANOU1, , Koutchika Roger DANVI1, Kpomagbé Serge DOSSOU1 and Emmanuel OLODO1

1Laboratory of Energy and Applied Mechanics (LEMA), Polytechnic School of Abomey-Calavi (EPAC), University of Abomey-Calavi (UAC), Republic of Benin

Pub. Date: April 14, 2026

Cite this paper:
Kocouvi Agapi HOUANOU, Koutchika Roger DANVI, Kpomagbé Serge DOSSOU and Emmanuel OLODO. Determination of the Mechanical Characteristics of Silty Sand Improved to Granite Crushed for Use in Road Construction in Southern Benin. American Journal of Civil Engineering and Architecture. 2026; 14(2):46-53. doi: 10.12691/ajcea-14-2-3

Abstract

Faced with the growing shortage of conventional materials in road construction in South Benin, this study explores the valorization of the silty sand of Tohouè, an abundant local resource but unsuitable for the raw state because of its low lift and its sensitivity to water. The general objective is to evaluate the effectiveness of mechanical stabilization by adding Dan's 0/31.5 granite crusher to allow its use in road construction. The methodology consisted in formulating eight mixtures with crushed contents ranging from 10% to 45%, characterized by standardized geotechnical tests: particle size analysis, Atterberg limits, methylene blue value, modified Proctor and CBR index after immersion. The results demonstrate a gradual improvement in mechanical properties. The mixture with 20% crushed material already shows a marked improvement with a CBR of 58.4% and a density of 1.99 g/cm³, meeting the CEBTP standard. However, it is the 25% blend that constitutes the technical optimum, achieving a CBR of 63.65% and a density of 1.995 g/cm³, fully meeting the requirements of international standards for foundation layers. Therefore, stabilization with 25% granite crushed represents the optimal formulation, offering the best compromise between mechanical performance and economic viability. This solution allows a 75% saving on the use of noble materials while valuing an abundant local resource, thus constituting a sustainable alternative for road construction in Benin.

Keywords:
silty sand crushed granite geotechnical tests foundation layers stabilization

Creative CommonsThis work is licensed under a Creative Commons Attribution 4.0 International License. To view a copy of this license, visit http://creativecommons.org/licenses/by/4.0/

References:

[1]  S. K. DOSSOU, "Valorisation en technique routière de la grave latéritique de Avlamè en République du Bénin," THESE, EPAC/UAC, Abomey-Calavi, 2023.
 
[2]  Houanou, K. A, Danvi, K. R, Dossou, K. S. et Olodo, E. "Determination of the Mechanical Parameters of Dan Granite Crushed Rock for Use in Road Construction in Benin," Open Journal of Civil Engineering, 15(3) 478‑502, août 2025.
 
[3]  Houanou, K. A, Danvi, K. R, Dossou, K. S. et Olodo, E. "Determination of the Geotechnical Parameters of Tohouè Silty Sand (Semè-Kpodji) for Its Use in Road Construction in Southern Benin," Open Journal of Applied Sciences, 15(7), juill. 2025.
 
[4]  Houanou, K. A, Dossou, K. S, Prodjinonto, V, Ahouétohou, P. et Olodo, E. " Mechanical characteristics of Avlamè lateritic gravel improved with granite crushed for its use in road construction in Benin," World Journal of Advanced Research and Reviews, 15(2), 279‑292, 2022.
 
[5]  Koubikana Pambou, C. H. "Développement d’un catalogue de conception des chaussées pour les pays Sub-Sahariens," PhD Thesis, École de technologie supérieure, 2013. https:// espace. etsmtl.ca/ id/eprint/1180/.
 
[6]  Molenaar, A. A. A. "Durable and sustainable road constructions for developing countries," Procedia Engineering, 54, 69‑81, 2013.
 
[7]  Ahouet, L, Ngoulou, M. O, Okina, S. N. et Dzaba, S. "Geotechnical Characterization of Termite Mound Soils of Congo," Open Journal of Civil Engineering, 12(3), juill. 2022.
 
[8]  Autret, P. "Laterites and Lateritic Soils / Latérites et sols latéritiques," ORSTOM. in Recherches, 66. Paris: ORSTOM, 1983.
 
[9]  O. BABALIYE, "Comportement élastique non linéaire des mélanges de graves latéritiques et du concassé granitique non liés en couche support des chaussées souples," PhD Thesis, EPAC/UAC, 2020.
 
[10]  M. Ndiaye, "Contribution à l’étude de sols latéritiques du Sénégal et du Brésil," PhD Thesis, Université Paris-Est ; Université Cheikh Anta Diop (Dakar, Sénégal), 2013. https://theses.hal.science/tel-00977354/.
 
[11]  CEBTP, "Guide pratique de dimensionnement des chaussées pour les pays tropicaux," 2ème Edition, in La documentation française, PARIS, 154, 1984.
 
[12]  CEBTP, Revue du guide pratique de dimensionnement des chaussées pour les pays tropicaux, CEBTP. 2019.
 
[13]  ZOMAHOUN, C. V, HOUANOU, A. K, et VIANOU, C. A. "Modélisation du comportement hypoélastique du mélange grave latéritique et du concassé granitique," 2020.
 
[14]  NF EN 933-8, "Essais pour déterminer les caractéristiques géométriques des granulats - Partie 8 : évaluation des fines. Équivalent de sable," AFNOR, 7, août 1999.
 
[15]  NF EN 1097-1, "Essais pour déterminer les caractéristiques mécaniques et physiques des granulats - Partie 1 : détermination de la résistance à l’usure (micro-Deval)" 24, déc. 2023.
 
[16]  AASHTO T 96-22, "Standard Method of Test for Resistance to Degradation of Small-Size Coarse Aggregate by Abrasion and Impact in the Los Angeles Machine (ASTM Designation: C131-01)," 2022.
 
[17]  NF EN 1097-2, "Essais pour déterminer les caractéristiques mécaniques et physiques de granulats - Partie 2 : méthodes pour la détermination de la résistance à la fragmentation," 34, 2010.
 
[18]  NFP 94-056, "Sols : reconnaissance et essais-Analyse granulométrique-Méthode par tamisage à sec après lavage" Association Française de Normalisation France, 1996.
 
[19]  NF P94-068, "Sols : Recherche et essais – Mesure de la capacité d’adsorption du bleu de méthylène d’un sol rocheux. Détermination du bleu de méthylène d’un sol par essai de déformation," AFNOR, octobre 1998.
 
[20]  NF P94-050, "Sols : reconnaissance et essais - Détermination de la teneur en eau pondérale des sols - Méthode par étuvage," Association Française de Normalisation France, 1991.
 
[21]  NF P94-051, "Reconnaissance et essai de détermination des limites d’Atterberg," France, AFNOR, 1993.
 
[22]  NF P94-093, 'Sols : reconnaissance et essais - Détermination des références de compactage d’un matériau - Essai Proctor Normal - Essai Proctor modifié" AFNOR, octobre 2014.
 
[23]  NF P94-078, "Sols : reconnaissance et essais-Indice CBR après immersion, Indice CBR immédiat. Indice Portant Immédiat-Mesure sur échantillon compacté dans le moule CBR," AFNOR, 1997.
 
[24]  XP P94-202 "Sols : reconnaissance et essais : prélèvement des sols et des roches : méthodologie et procédures." La Plaine Saint-Denis Cedex: AFNOR, 44, 1995.
 
[25]  M. D. Gidigasu, "Laterite Soil Engineering. Pedogenesis and Engineering Principles," 1976.
 
[26]  M. Gidigasu, "Laterite soil engineering: pedogenesis and engineering principles, 9. Elsevier Amsterdamz,9, 554, 2012. ISBN+978-0-444-41433-2.
 
[27]  NF P94-049-2, "Sols : reconnaissance et essais - Détermination de la teneur en eau pondérale des matériaux - Partie 2 : méthode à la plaque chauffante ou panneaux rayonnants," AFNOR, France, 9, février 1996.
 
[28]  AFNOR XP 94-047, "Sols : reconnaissance et essais - Détermination de la teneur pondérale en matières organiques d’un matériau - Méthode par calcination," La Plaine Saint-Denis Cedex : AFNOR, 8,1998. https://fr.scribd.com/document/492030284/P94-047-teneur-en-matiere-organique-par-calcination.
 
[29]  Sadeeq, J. A, Ochepo, J, Salahudeen, A. B. et S. T. Tijjani, "Effect of bagasse ash on lime stabilized lateritic soil," Jordan Journal of Civil Engineering, 9(2) 2015.
 
[30]  H. H. Weinert, "Natural road construction materials of Southern Africa," 1980, https://researchspace.csir.co.za/items/b5faaac6-1e69-4d1c-ae2e-2700d6e4d929.
 
[31]  NM 10.1.008, "Matériaux de construction - Graves et graves-bitume - Spécifications" Institut Marocain de Normalisation, Rabat, MAROC, 24, 2007.
 
[32]  Riverson, J. Gaviria, J. et Thriscutt, S. "Rural roads in sub-Saharan Africa," World Bank Technical Paper, 41, 1991. https:// roadsforwater.org/wp-content/uploads/2013/11/rural-roads-in-SSA_lessons-from-the-WB-experience.pdf.
 
[33]  Van R. M. et Winterkorn, H. F. "STRUCTURAL AND TEXTURAL INFLUENCES ON THERMAL CONDUCTIVITY OF SOILS," Highway Research Board Proceedings, 38, 1959. https://trid.trb.org/View/121613.