Article citationsMore >>

Lai, C., and Troesch, A.W., “Modeling issues related to the hydrodynamics of three-dimensional steady planing,” J. Ship Res., Vol. 39, p.1, 1995.

has been cited by the following article:

Article

RANS Simulation of Dynamic Trim and Sinkage of a Planing Hull

1Cocoa Research Institute of Nigeria, Ibadan, Nigeria


Applied Mathematics and Physics. 2013, Vol. 1 No. 1, 6-10
DOI: 10.12691/amp-1-1-2
Copyright © 2013 Science and Education Publishing

Cite this paper:
Parviz Ghadimi, Seyed Hamid Mirhosseini, Abbas Dashtimanesh, Mohammad Amini. RANS Simulation of Dynamic Trim and Sinkage of a Planing Hull. Applied Mathematics and Physics. 2013; 1(1):6-10. doi: 10.12691/amp-1-1-2.

Correspondence to: Parviz Ghadimi, Cocoa Research Institute of Nigeria, Ibadan, Nigeria. Email:

Abstract

In this article, a RANS solver is implemented to model a planing hull motion in calm water. K-E turbulent model is also utilized to capture details around the planing hull and, correspondingly, force acting on the hull. Furthermore, an individual mesh is adopted by combination of structured and unstructured mesh. To verify capability of the considered mesh, steady state solution of a planing hull is investigated and it is observed that numerical settings are adequate for determining planing motion. Finally, a hard chine planing hull is considered and dynamic sinkage and trim are computed. Comparisons of the obtained results with experimental data show a relatively good agreement and it can be concluded that the presented method can be used for practical studies in initial design.

Keywords