Article citationsMore >>

IŽARÍKová, G.: Modely pre automatizované projektovanie montážnych systémov, Dizertačná práca, SjF TU v Košiciach, 2008.

has been cited by the following article:

Article

Geometric Transformations in the Design of Assembly Systems

1Department of Industrial engineering and management, Faculty of Mechanical Engineering, Technical University of Košice, Košice, Slovakia

2Department of Applied mathematics and informatics, Technical University of Košice, Košice, Slovakia


American Journal of Mechanical Engineering. 2013, Vol. 1 No. 7, 434-437
DOI: 10.12691/ajme-1-7-56
Copyright © 2013 Science and Education Publishing

Cite this paper:
Milan Fiľo, Jaromír Markovič, Gabriela Ižaríková, Peter Trebuňa. Geometric Transformations in the Design of Assembly Systems. American Journal of Mechanical Engineering. 2013; 1(7):434-437. doi: 10.12691/ajme-1-7-56.

Correspondence to: Peter  Trebuňa, Department of Industrial engineering and management, Faculty of Mechanical Engineering, Technical University of Košice, Košice, Slovakia. Email: peter.trebuna@tuke.sk

Abstract

The design of the assembly systems is an important role optimizing the spatial resolution. An important tool for the problem solving is approaches to mathematics based modeling. The article presents the basic geometric transformations to identify the location.

Keywords