Article citationsMore >>

F. Menda, F. Trebuňa, P. Šarga: Estimation of residual stress field uniformity when using the Ring-Core method. Advanced Materials Research Vol. 996 (2014) pp 325-330.

has been cited by the following article:

Article

Comparison of Different Simulation Approaches in Ring-Core Method

1Technical University of Košice, Faculty of Mechanical Engineering, Department of Applied Mechanics and Mechanical Engineering, Košice, Slovakia

2Technical University of Košice, Faculty of Mechanical Engineering, Department of Mechatronics, Košice, Slovakia


American Journal of Mechanical Engineering. 2014, Vol. 2 No. 7, 258-261
DOI: 10.12691/ajme-2-7-17
Copyright © 2014 Science and Education Publishing

Cite this paper:
František Menda, Patrik Šarga, Tomáš Lipták, František Trebuňa. Comparison of Different Simulation Approaches in Ring-Core Method. American Journal of Mechanical Engineering. 2014; 2(7):258-261. doi: 10.12691/ajme-2-7-17.

Correspondence to: František  Menda, Technical University of Košice, Faculty of Mechanical Engineering, Department of Applied Mechanics and Mechanical Engineering, Košice, Slovakia. Email: frantisek.menda@tuke.sk

Abstract

Ring-Core, a semi-destructive method enables measurement of the residual stresses inside the material by the sensor attached at the top of the specimen. Such stress reconstruction requires proper determination of the calculation coefficients. Thus the simulation model for finite elements analyzes is created by means of two different commercial software. Subsequently both simulation results are compared experimentally by measurement on the specimen loaded by known uniaxial state of stress.

Keywords