Article citationsMore >>

Trebuňa, F., Jadlovský, J., Frankovský, P., Pástor, M., Automatizácia v metóde Photostress [Automation in PhotoStress method]. 1. issue. Košice: TU – 2012.

has been cited by the following article:

Article

Stress Analysis of a Rotating Body by Means of Photostress Method and Using Solidworks Programme

1Technical University of Košice, Faculty of Mechanical Engineering, Košice, Slovakia


American Journal of Mechanical Engineering. 2014, Vol. 2 No. 7, 226-230
DOI: 10.12691/ajme-2-7-11
Copyright © 2014 Science and Education Publishing

Cite this paper:
Ján Kostka, Peter Frankovský, František Trebuňa, Miroslav Pástor, František Šimčák. Stress Analysis of a Rotating Body by Means of Photostress Method and Using Solidworks Programme. American Journal of Mechanical Engineering. 2014; 2(7):226-230. doi: 10.12691/ajme-2-7-11.

Correspondence to: Ján  Kostka, Technical University of Košice, Faculty of Mechanical Engineering, Košice, Slovakia. Email: jan.kostka@tuke.sk

Abstract

The paper is dedicated to the examination of stress states of a rotating body which occur due to centrifugal forces. In order to determine stress and stain distribution, photoelastic PhotoStress method was applied and a measurement device – polariscope LF/Z-2 was used. The sample under examination was subjected to loads of various magnitudes and, subsequently, recorded with a photographic device. For objective evaluation of detected results, the object under examination was modelled and simulated in programme SolidWorks 2012.

Keywords