Article citationsMore >>

Fukuoka T. and Nomura M., Proposition of Helical Thread Modelling with accurate Geometry and Finite Element Analysis, Journal of Pressure Vessel Technology, Vol. 130, 2008, pp. 011204-1 - 011204-6.

has been cited by the following article:

Article

Possibility of Carrying Capacity Increasing of Anchor Bolts in Heavy Equipments of Metallurgical Plants

1Department of Applied Mechanics and Mechatronics, Faculty of Mechanical Engineering, Technical university of Košice, Košice, Slovakia


American Journal of Mechanical Engineering. 2013, Vol. 1 No. 7, 403-406
DOI: 10.12691/ajme-1-7-50
Copyright © 2013 Science and Education Publishing

Cite this paper:
František Trebuňa, František Šimčák, Jozef Bocko. Possibility of Carrying Capacity Increasing of Anchor Bolts in Heavy Equipments of Metallurgical Plants. American Journal of Mechanical Engineering. 2013; 1(7):403-406. doi: 10.12691/ajme-1-7-50.

Correspondence to: František  Šimčák, Department of Applied Mechanics and Mechatronics, Faculty of Mechanical Engineering, Technical university of Košice, Košice, Slovakia. Email: frantisek.simcak@tuke.sk

Abstract

Abstract Anchor bolts in heavy machines of metallurgical plants are often, from the point of view of their carrying capacity, limiting factor in increasing productivity. This paper presents some possibilities of increasing strength of anchor bolts using numerical and experimental methods of mechanics. Proposed and verified procedures allow determining the actual stress states during tightening the anchor bolts and nuts and reduce dynamic loads in bolts as well as in operating machines.

Keywords