Article citationsMore >>

Henzold G.: Geometrical Dimensioning and Tolerancing for Design, Manufacturing and Inspection. Elsevier Ltd. 2006.

has been cited by the following article:

Article

Comparison of the Cylindricity Deviation Using Different Evaluation Methods

1Technical University, Mechanical Engineering Faculty, Department of Biomedical Engineering and Measurement, Košice, Slovakia


American Journal of Mechanical Engineering. 2013, Vol. 1 No. 7, 339-342
DOI: 10.12691/ajme-1-7-37
Copyright © 2013 Science and Education Publishing

Cite this paper:
Miroslav Dovica, Alexander Végh. Comparison of the Cylindricity Deviation Using Different Evaluation Methods. American Journal of Mechanical Engineering. 2013; 1(7):339-342. doi: 10.12691/ajme-1-7-37.

Correspondence to: Miroslav  Dovica, Technical University, Mechanical Engineering Faculty, Department of Biomedical Engineering and Measurement, Košice, Slovakia. Email: miroslav.dovica@tuke.sk

Abstract

This paper deals with the measurement and the evaluation of cylindricity deviation of the rotational symmetrical workpiece. Coordinate Measuring Machine (CMM) with X-Ray tomography was used for the measurement. For the evaluation of the cylindricity deviation, we applied standard Gaussian cylinder. Data obtained by the measurement is compared using the VG Studio and Calypso software. At the end of this paper, the experimental data is presented.

Keywords