Article citationsMore >>

Šarga, P.: Riadenie odvŕtavania a vyhodnocovania zvyškových napätí, DDP TU v Košiciach, September 2005.

has been cited by the following article:

Article

Analysis of Influence of Strain Gage Rosette on Relieved Strain

1Department of Applied Mechanics and Mechatronics, Technical university in Košice, Faculty of Mechanical Engineering,; Letná 9, 040 01 Košice, Slovakia


American Journal of Mechanical Engineering. 2013, Vol. 1 No. 7, 309-312
DOI: 10.12691/ajme-1-7-31
Copyright © 2013 Science and Education Publishing

Cite this paper:
Patrik Šarga, Peter Senko, František Trebuňa. Analysis of Influence of Strain Gage Rosette on Relieved Strain. American Journal of Mechanical Engineering. 2013; 1(7):309-312. doi: 10.12691/ajme-1-7-31.

Correspondence to: Patrik  Šarga, Department of Applied Mechanics and Mechatronics, Technical university in Košice, Faculty of Mechanical Engineering,; Letná 9, 040 01 Košice, Slovakia. Email: patrik.sarga@tuke.sk

Abstract

Hole-drilling method is the most widely used method for measuring residual stresses. This method is performed using strain gage rosette attached to the surface of the studied components, through which we drill blind or through-hole. This paper is devoted to analyzing of influence of strain gage rosette on relieved strain. Our aim was to establish more accurately model of strain gage rosette, and examine its effect on hardening of the surface around the hole. For modeling by FEM was used strain gage rosette RY 21 made by HBM.

Keywords