Article citationsMore >>

TREBUŇA, F. - ŠIMČÁK, F. Príručka experimentálnej mechaniky, SjF TU, Košice, 2007.

has been cited by the following article:

Article

Modal Analysis of Titan Cantilever Beam Using ANSYS and SolidWorks

1Department of Applied Mechanics and Mechatronics, Technical University of Košice, Košice, Slovakia


American Journal of Mechanical Engineering. 2013, Vol. 1 No. 7, 271-275
DOI: 10.12691/ajme-1-7-24
Copyright © 2013 Science and Education Publishing

Cite this paper:
Pavol Lengvarský, Jozef Bocko, Martin Hagara. Modal Analysis of Titan Cantilever Beam Using ANSYS and SolidWorks. American Journal of Mechanical Engineering. 2013; 1(7):271-275. doi: 10.12691/ajme-1-7-24.

Correspondence to: Pavol  Lengvarský, Department of Applied Mechanics and Mechatronics, Technical University of Košice, Košice, Slovakia. Email: pavol.lengvarsky@tuke.sk

Abstract

In this paper are given basic steps of the modal analysis simulation. The modal analysis is carried out on the titan cantilever beam. The cantilever beam is designed in the graphical environment of the ANSYS and SolidWorks. The cantilever beam was fixed on one end and all degrees of freedom on this end were taken, beam cannot move and rotate. Mode shapes and natural frequencies are computed in programs ANSYS and SolidWorks with numerical formulation of the direct solver including the block Lanczos method.

Keywords