Article citationsMore >>

Y. M. Mohamed K. Hassan, Abu El-Ainin H, "Improvement of Al-6061 alloys mechanical properties by controlling processing parameters," International Journal of Mechanical & Mechatronics Engineering IJMME-IJENS, vol. 12, pp. 14-18, 2012.

has been cited by the following article:

Article

Complete Design and Assemble of Wind Turbine Bald

1Mechanical Engineering department, Faculty of Engineering, South Valley University, Qena, Egypt

2Mechanical Engineering Department, Collage of Engineering and Islamic Architecture, Umm Al-Qura University Makkah, KSA

3Mechanical Engineering Department, Faculty of Engineering, Sohage University, Egypt


American Journal of Mechanical Engineering. 2019, Vol. 7 No. 1, 9-19
DOI: 10.12691/ajme-7-1-2
Copyright © 2019 Science and Education Publishing

Cite this paper:
Mohammed Y. Abdellah, Mohammad Sh. Alazemi, Ahmed F. Mohamed, G. Tag Abdel-Jaber. Complete Design and Assemble of Wind Turbine Bald. American Journal of Mechanical Engineering. 2019; 7(1):9-19. doi: 10.12691/ajme-7-1-2.

Correspondence to: Mohammed  Y. Abdellah, Mechanical Engineering department, Faculty of Engineering, South Valley University, Qena, Egypt. Email: mohammed_yahya42@yahoo.com

Abstract

the feasibilities of using wind energy in the Kuwait have analyzed and investigated. The wind speed level and resources in Kuwait was investigated experimentally. The aerodynamic of the rotor of wind turbine is investigated experimentally. Aerodynamic of wind turbines is studied theoretical using Flo software based on the theoretical models. All components of wind turbine are selected and manufactured in Kuwait. The required materials for assembling rotor and main shaft were performed. The material of the turbine is investigated for stage of building and assembling.

Keywords