Article citationsMore >>

Yih-Fang Chang, “DSP-Based Ignition Delay Monitor and Control of an Electro-Discharge Machining Process”, Intelligent Automation and Soft Computing, 13/2, 2007, pp. 139-151.

has been cited by the following article:

Article

Development of Flexible Machine Controller for Electrical Discharge Machine

1Department of Mechanical Engineering, Govt. Polytechnic, Arvi, Maharashtra, India

2Department of Mechanical Engineering, National Institute of Technical Teachers Training & Research, Chandigarh, India


American Journal of Mechanical Engineering. 2018, Vol. 6 No. 2, 48-53
DOI: 10.12691/ajme-6-2-2
Copyright © 2018 Science and Education Publishing

Cite this paper:
M. M. Pawade, S. S. Banwait. Development of Flexible Machine Controller for Electrical Discharge Machine. American Journal of Mechanical Engineering. 2018; 6(2):48-53. doi: 10.12691/ajme-6-2-2.

Correspondence to: S.  S. Banwait, Department of Mechanical Engineering, National Institute of Technical Teachers Training & Research, Chandigarh, India. Email: ssbmec@gmail.com

Abstract

The present experimental work involved the development and evaluation of Flexible Machine Controller for die sinking Electrical Discharge Machine (EDM). Pilot experimentations were conducted to develop a comprehensive EDM experimental database. The Flexible Machine Controller development dealt with the selection and programming of Programmable Logical Controller. The user interface has been developed on the basis of Supervisory Control and Data Acquisition system and the database program has been developed for assisting the user in selection of EDM process parameters. The developed Flexible Machine Controller has been validated with the experimental database. Experimentations carried out for six different work piece materials with the developed Flexible Machine Controller showed 13.12% improvement in the machining time as compared to original machine controller.

Keywords