Article citationsMore >>

Chetan, N. B. and Wankhade, N. A., Finite Element Stress Analysis of Crane Hook with Different Cross Sections, International Journal For Technological Research In Engineering, 1(9). 868-872, 2014.

has been cited by the following article:

Article

Full-field Stress Analysis of a Crane Hook Model Performed by Finite Element Analysis and Digital Image Correlation Method

1Department of Applied Mechanics and Mechanical Engineering, Technical University of Košice, Faculty of Mechanical Engineering, Košice, Slovakia


American Journal of Mechanical Engineering. 2017, Vol. 5 No. 6, 293-297
DOI: 10.12691/ajme-5-6-12
Copyright © 2017 Science and Education Publishing

Cite this paper:
Martin Hagara, Miroslav Pástor. Full-field Stress Analysis of a Crane Hook Model Performed by Finite Element Analysis and Digital Image Correlation Method. American Journal of Mechanical Engineering. 2017; 5(6):293-297. doi: 10.12691/ajme-5-6-12.

Correspondence to: Martin  Hagara, Department of Applied Mechanics and Mechanical Engineering, Technical University of Košice, Faculty of Mechanical Engineering, Košice, Slovakia. Email: martin.hagara@tuke.sk

Abstract

The contribution deals with a full-field stress analysis of the crane hook model. The investigation was realized using numerical as well as experimental analysis. In numerical analysis, the software based on finite element method was used. Experimental analysis was performed in laboratory conditions via non-contact optical method of digital image correlation. The results in a form of von Mises stress obtained by both approaches along identical virtual line gages, were depicted and compared. The paper briefly describes the methodologies of both, experimental and numerical types of modeling.

Keywords