Article citationsMore >>

http://www.grayson-engineering.co.nz/capability.php?a=CellularBeams

has been cited by the following article:

Article

Possibilities of Optimizing the Shape and Geometry of Castellated Beams Using Numerical and Experimental Modeling

1Department of Applied Mechanics and Mechanical Engineering, Technical University of Košice, Faculty of Mechanical Engineering, Letná 9, Košice, 04200, Slovakia


American Journal of Mechanical Engineering. 2016, Vol. 4 No. 7, 357-362
DOI: 10.12691/ajme-4-7-22
Copyright © 2016 Science and Education Publishing

Cite this paper:
Miroslav Pástor, Jozef Bocko, Tomáš Kula, Cosmin-Stefan Roszkos. Possibilities of Optimizing the Shape and Geometry of Castellated Beams Using Numerical and Experimental Modeling. American Journal of Mechanical Engineering. 2016; 4(7):357-362. doi: 10.12691/ajme-4-7-22.

Correspondence to: Tomáš  Kula, Department of Applied Mechanics and Mechanical Engineering, Technical University of Košice, Faculty of Mechanical Engineering, Letná 9, Košice, 04200, Slovakia. Email: tomas.kula@tuke.sk

Abstract

The article discusses about numerical methods and physics experiment for studying stress fields caused by defined load on beam. Examined the behavior of material under various modes load at individual types of beams. The results are compared, and then the right conclusions are drawn, that it is possible to verify the physical experiment and numerical calculation. For physical experiment was used transmission photoelasticimetry.

Keywords