Article citationsMore >>

Fűrbacher, I., et al., Lexicon of Technical Materials, Part 1, (In Czech), Verlag Dashőfer, 2005.

has been cited by the following article:

Article

Defects in the Bearing Elements of the Equipment for High-pressure Die Casting

1Department of Applied Mechanics and Mechanical Engineering, Technical University of Košice, Faculty of Mechanical Engineering, Letná 9, Košice, 04200, Slovakia


American Journal of Mechanical Engineering. 2016, Vol. 4 No. 7, 266-270
DOI: 10.12691/ajme-4-7-7
Copyright © 2016 Science and Education Publishing

Cite this paper:
František Trebuňa, František Šimčák, Miroslav Pástor. Defects in the Bearing Elements of the Equipment for High-pressure Die Casting. American Journal of Mechanical Engineering. 2016; 4(7):266-270. doi: 10.12691/ajme-4-7-7.

Correspondence to: Miroslav  Pástor, Department of Applied Mechanics and Mechanical Engineering, Technical University of Košice, Faculty of Mechanical Engineering, Letná 9, Košice, 04200, Slovakia. Email: miroslav.pastor@tuke.sk

Abstract

The paper presents the results of the analysis of failure in the bearing elements of the equipment of the locking mechanism of the high-pressure press for high-pressure casting of products made from aluminum alloy. Based on the analysis of the operating conditions of the press, material of the failed stationary plate and its stress analysis using FEM for various cases of loading, conclusions regarding possible causes of the plate failure were drawn.

Keywords