American Journal of Mechanical Engineering
ISSN (Print): 2328-4102 ISSN (Online): 2328-4110 Website: http://www.sciepub.com/journal/ajme Editor-in-chief: Kambiz Ebrahimi, Dr. SRINIVASA VENKATESHAPPA CHIKKOL
Open Access
Journal Browser
Go
American Journal of Mechanical Engineering. 2016, 4(7), 353-356
DOI: 10.12691/ajme-4-7-21
Open AccessSpecial Issue

Modern Trends in the Field of Measurement of Residual Stresses Using Hole-Drilling Method

Patrik Šarga1, and František Trebuňa2

1Department of Mechatronics, Faculty of Mechanical Engineering, Technical University of Košice, Letná 9, 042 00 Košice, Slovak Republic

2Department of Applied Mechanics and Mechanical Engineering, Faculty of Mechanical Engineering, Technical University of Košice, Letná 9, 042 00 Košice, Slovak Republic

Pub. Date: December 17, 2016

Cite this paper:
Patrik Šarga and František Trebuňa. Modern Trends in the Field of Measurement of Residual Stresses Using Hole-Drilling Method. American Journal of Mechanical Engineering. 2016; 4(7):353-356. doi: 10.12691/ajme-4-7-21

Abstract

Residual stresses in the constructions have in most cases a negative effect on their overall life. Large numbers of investigations have been carried out to study this phenomenon and its effect on the mechanical characteristics of these constructions or their components. Hole-drilling method is one of the most used methods used for the determination of residual stresses. This method typically uses strain gauges. This article describes options of using optical methods instead of strain gauge in the process of evaluation of residual stresses by hole-drilling method.

Keywords:
residual stresses hole-drilling method optical methods

Creative CommonsThis work is licensed under a Creative Commons Attribution 4.0 International License. To view a copy of this license, visit http://creativecommons.org/licenses/by/4.0/

Figures

Figure of 10

References:

[1]  Steinzig, M., Ponslet, E. (2003) “Residual Stress Measurement Using the Hole Drilling Method and Laser Speckle Interferometry: Part I.” Experimental Techniques 27(3):43-46.
 
[2]  http://www.stresstech.com/en-fi/products/espi-hole-drilling-equipment/prism-equipment.
 
[3]  Nelson, D. V., Makino, A., Schmidt, T. (2006) “Residual Stress Determination Using Hole Drilling and 3D Image Correlation.” Experimental Mechanics 46(1):31-38.
 
[4]  Frankovský, P.: Využitie experimentálnych metód mechaniky pri určovaní zvyškových napätí, TU v Košiciach, September 2010, Košice.
 
[5]  Frankovský, P., Kostelníková, A., Šarga, P.: The use of strain-gage method and PhotoStress method in determining residual stresses of steel console, In: Metalurgija. Vol. 49, no. 2 (2010), p. 208-212.
 
[6]  Frankovský, P. a kol.: Utilisation Possibilities of PhotoStress Method in Determination of Residual Stresses, In: Applied Mechanics and Materials. Vol. 732 (2015), p. 3-8.
 
[7]  Schajer, G. S.: Practical Residual Stress Measurement Methods, 2013.